Tractor Talk Discussion Board |
Re: OT Electronic Ballasts
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by txblu on November 15, 2004 at 11:51:05 from (199.46.199.233):
In Reply to: Re: OT Electronic Ballasts posted by FarmerDave on November 15, 2004 at 11:26:53:
The 9.95's work well. I have a 25 year old shop that hasn't had one replaced. Only changed bulbs like every 5 years. I have found out that if your bulbs are weak, the cold weather will tell you. Hear you on the stove. I have a lot of used oil that I get the recycler to come and pick up. Would be nice to have a double 55 drip stove but I usually am involved with some sort of flammable when in the shop and I don't want the risk either. What I do is run a propane jet engine. Mines 30,000 BTU. HD now has some with 100,000. I fire it off and get the building warm (while sitting in front of it with my shoes off) and then turn it off and get out the bad stuff. When finished, I open the door, fan out the fumes, close her up and get warm again. Works pretty good. Mark
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|