Re: 3 angle valve grinding??

Posted by Dick L on November 12, 2004 at 14:00:06 from (209.210.233.47):

In Reply to: 3 angle valve grinding?? posted by Lynn Kasdorf on November 12, 2004 at 13:03:22:

The three angle grinding has the valve face seating on the center much narrower seat. Less area seated so supposed to be a tighter seat to hold more compression pressure. Unless you are stroking the crank, way oversizing the pistons, and putting in high domed pistons, I wouldn"t think it would do much to help these small 125 engines. In saying that, I am sure it wouldn"t hurt if the seats were done that way. I have the cutters and equipment to do it but have not on a regular valve grind. Just on special jobs for the higher compression.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]