Tractor Talk Discussion Board |
Re: OT Can We Talk Dump Trucks
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by BIlly NY on June 20, 2007 at 20:36:31 from (205.188.117.71):
In Reply to: OT Can We Talk Dump Trucks posted by Trucker? on June 20, 2007 at 14:49:54:
I think you have the best of both worlds on opinion's here. Say for hauling to residential customers, if you have the sales of a material that people want, it can be lucrative, there is a plethora of used single axles out there ranging from 5-30 years old. You can get a single axle very reasonably and they are handy for tight areas, smaller loads etc. I don't like the smaller one tons like what they used to call a masons dump, prefer just a little more truck, like a S/A, matter of preference I suppose. When you get into the tandems, tri-axles etc. you need to find steady work for it, either your own work like excavation, or selling a material you make or quarry etc, or you'll need to hook up with a construction company needing trucks for their jobs to keep it busy. You'll need to find some steady hauling for it, no matter what it is, has to be one that pays, these big ones are not cheap to run or fix, the work has to pay for the truck, maintenance and your salary + a little extra. I used to run singles, tandems and triaxles, while employed by site work contractors, early in my career, was good learning experience, I did not like being in a truck most of the day though, preferred running equipment on a site. ALways found that a versatile single axle was very handy. I have an old single axle dump, was a grain truck and I use it to haul a compost material that I make, it works well, truck is not too bad to keep up on and the material sells for over $25 a yard, 10 yds = $250 per load, homeowners buy the material, so it does provide some extra $$.
Replies:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|