|
Tractor Talk Discussion Board |
Re: Studded Tractor Tires
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hoosier JD on November 07, 2004 at 10:15:08 from (64.12.117.7):
In Reply to: Studded Tractor Tires posted by Moose on November 07, 2004 at 09:00:55:
Moose.........I worked in a tire store while going through college. I studded many snow tires for cars and trucks! The tires at that time had to have holes from the tire manufacturer so the studs could be installed. I ran them and they were great on packed snow and/or ice. A special gun was used to install the studs. A rotating bin dropped studs through a tube and through the gun. The nose of the gun was inserted into the holes in the tread of the tire, the mechanism of the gun then spread the hole out enough so that the "head" (similar to a nail) could be shot into the hole with air, and so was locked in the tread. If you can find tires with the holes, you might have a chance....otherwise, in my opinio, you are SOL.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|