|
Tractor Talk Discussion Board |
Re: Starter fluid
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RAB on November 06, 2004 at 10:59:02 from (195.93.34.11):
In Reply to: Starter fluid posted by Fence on November 05, 2004 at 19:36:44:
Here is a simple question. Do you regularly make it work hard or does it just "pussy-foot" round with a lawn mower on the back most year round? I mean giving it at least half a day hard plowing. Odds on the answer is "no". If that is the case, then you possibly have glazed bores, poorly seating rings and low compression, resulting in poor starting. I would expect some oil usage in this condition. Have you checked the valve clearances lately?. It might just need a service. Is the thermostat working properly. If the engine is run too cool all the time there could well be build up around the injector nozzles leading to poor starting. What is the pop pressures for the injectors. If too low it may well manifest itself as poor starting. Is the pump timed correctly. Should be .....but...if not result can be poor starting. Will it restart if, on starting in the morning, you immediately stop it before it warms up and then come back to start it in, say, an hours time? If it is OK afterthe hour or two it may be a leak in the injection system (like posted below or elsewhere}. Is the battery/charging system up to scratch? Is the starter motor running at a good speed? Either could cause poor starting due to slow cranking. Not a lot, but just a few points to clear up before we progress deeper with the problem. Could be any of these and several others. Alternatively it may soon need a major overhaul
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|