|
Tractor Talk Discussion Board |
Re: A Comparison
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Indydirtfarmer on October 28, 2004 at 06:45:41 from (66.83.236.250):
In Reply to: A Comparison posted by Allan in NE on October 28, 2004 at 05:36:51:
Howdy Allan, I spent a while at Bismark, North Dakotah, back in 1976. It was the Bicentenial year, and also the 100th anniversary of the Battle of the Little Big Horn. Ft. Abraham Lincoln is just outside Bismark. (Near Mandan) That was the "home base' for General George Armstrong Custer. There is a national park there now. The fort has been preserved as a national monument. I was in the service of our country at that time (U.S. Army, 7th Cav.) We were sent to Ft Lincoln for a couple weeks to serve as Honor Guard during a re-enactment of Custer's leaving the fort to go "kill injuns". (You see where that got HIM!) Long story short. If I never see the "badlands" again, it'll be too soon. Just about the most feature-less terrain on the planet. Bismark is the state capital. The population of Bismark is over 1/2 the states total. It was the worst place in the world for a 19 year old "soldier-boy" to be stuck. Never want to see the place again... I didn't have much dealings with "the locals", but I can understand why they would be so grumpy. If i was stuck there, I'd be in a bad mood too. John
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|