|
Tractor Talk Discussion Board |
Re: Battery in my Workmaster
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by txblu on October 22, 2004 at 12:18:54 from (199.46.199.230):
In Reply to: Re: Battery in my Workmaster posted by Coloken on October 22, 2004 at 07:27:53:
Ken, The rectifier diodes (6 ea) in the alternator do that for you (When they're good). In a generator system, the points in the VR have to open to disconnect the batt. The diode installation (the forum was yakin about) was to keep the alternator output from coming back thru the control line to supply enough power to operate the ignition coil at low rpm's and without it, the engine continues to run with the key off. I have one that does that and I'm too lazy (don't have one) to install one. Mark
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Step by Step 12-Volt Conversion - by Bob Melville. Below are step by step instructions to convert a 6 volt Farmall M or Super M with battery (not magneto) ignition to a 12 volt alternator electrical system.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|