Tractor Talk Discussion Board |
Re: Fascination with plowing...
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Indydirtfarmer on October 11, 2004 at 17:06:33 from (204.255.238.29):
In Reply to: Re: Fascination with plowing... posted by steve-ny on October 11, 2004 at 16:56:19:
The #810 is a little bit older. (just a VERY few years.) It was designed to go with the NEW Deere 800 hitch that was on early 50's 60's and 70's. They would work with 3 point hitch's but were primarily for the 800 hitch. The 415/416 (2 bottom or 3 bottom) was built for the 420, 430, and 435. It was a (somewhat) lighter framed, truss-frame catagory 1, 3 point plow. They were updated in late '59. (MOSTLY improvements to the furrow wheel.) Both used hss bottoms. I'm reasonably certain, but not sure that the 810 used hss400 series bottoms. The 416A used hss314 bottoms. The 416A was not offered in a 16" frame, as far as I know. John
Follow Ups:
Home
| Forums
Today's Featured Article -
Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|