|
Tractor Talk Discussion Board |
Re: What makes a tractor hard to start in the cold
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JDknut on October 07, 2004 at 09:23:34 from (152.119.204.74):
In Reply to: What makes a tractor hard to start in the cold? posted by Bob Spooner on October 07, 2004 at 05:04:37:
Get that pup good and warm, spin 'er over fast enough and get 'er fuel and she'll start. Up here where the temperature goes to 35 below zero F, that is how we get our diesels running. The biggest thing is the use of a block heater. At least two hours before you want to use it (more if it is really cold) plug it in and let it warm up then it'll start like the middle of summer. Keep the battery up and the cable connections cleaned. If it gets much colder than xero, you should put an anti-gel additive in the fuel. I don't like ether, I have seen what it does to engines and it is not pretty (or cheap). I prefer to plug it in and let it warm up. ALso, if it is real cold, you might want to takea it easy on the hydraulics until they warm up. Good luck!.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|