Tractor Talk Discussion Board |
Re: Home Made Ditch Bank Cutter
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by 3010 Ken on October 07, 2004 at 05:10:54 from (207.136.170.26):
In Reply to: Home Made Ditch Bank Cutter posted by Russ(NC) on October 07, 2004 at 04:38:49:
Russ,my dad owns a 4' bush hog made by modern equipment.I'm not sure if it could stand much of the 2" brush cutting you speak of though.You may be able to contact a local implement dealer and get the skinny on gear box H.P.ratings and abilities of hydrualic motors.Wonder if you might check on hiring someone to cut it then keep it sprayed.Just a few thoughts,have a good day.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|