8n Engine sleeves

Posted by Rick Rivera on October 05, 2004 at 23:13:04 from (4.26.158.138):

Hi, all you 8n gurus,

Just removed one sleeve after reading here about just heating them a little. I did that and then I tapped in screwdriver and the metal just pealed away and the sleeve fell out. I was wondering if my sleeve was cast or metal. I did not think that metal would just peal like that but read one post that says it would. Looking at the sleeve it looks like cast, has that grey powder look. I also measured it and it reads about .075" Thick so I guess I need the 090" sleevs? Do I need to put cast back in or steel?

Thanks in advance, Rick

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]