|
Tractor Talk Discussion Board |
Re: How HOT should a small engine run?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RayP(MI) on September 24, 2004 at 05:06:32 from (216.46.211.125):
In Reply to: How HOT should a small engine run? posted by Farmer in the Dells (WI) on September 24, 2004 at 04:56:14:
This is probably NOT the answer to your question, but may shed a little light. I have a B&S 8hp vertical shaft on a tow behind mower. From the factory, the rubber fuel line ran right over the muffler - factory had added a metal tubing sheath over that part of fuel line. Before I ran it the first time, I found a way to provide some separation between muffler and fuel line, by plastic wire tieing it away from muffler. That seemed to be courting disaster. I would check very carefully the routing of fuel line. Have you tried running it with a remotely located fuel tank?
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Buying your first tractor: The People You Buy From - by Chris Pratt. If you are a first-time buyer, chances are that you are likely to take the word of the seller on things. This is where the problems start... You have reviewed your implement needs and determined the size of machine that will fit the bill and even made a list of the most desirable models. You checked on the availability of a 3-point hitch for the machines on the list and advertised in your local classified paper with so
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|