|
Tractor Talk Discussion Board |
Re: electric ignition vs points
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mark - IN. on September 15, 2004 at 06:57:30 from (64.12.117.10):
In Reply to: electric ignition vs points posted by Wes in Ohio on September 15, 2004 at 05:59:46:
I guess that it all depends. Are ignition parts (points, condendor, distributor) still available for your tractors? As Ron pointed out, the cost of going out a replacement electronic ignition isn"t probably economically feasible, so long as existing OEM parts are available. Electronic ignition has been proven time and time again since it"s introduction in the mid to late 70"s (at least OEM), but it isn"t cheap if/when it breaks. As for aftermarket electronic ignition, very expensive to purchase, very expensive to fix or replace, certainly if compaired to what you already have installed. Bet it"d be easy to find/scrounge up pieces for your existing ignition setup than to find for a new aftermarket setup in a few years, and certainly cheaper. I guess it depends on you. What do you want? How deep is your pocket book? Going to race that tractor, or just use it around the farm? The choices are yours.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|