Tractor Talk Discussion Board |
Re: 6v to 12v conversions (ford 850)
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by apekim on September 01, 2004 at 08:52:20 from (155.212.250.62):
In Reply to: 6v to 12v conversions posted by TheRealRon on September 01, 2004 at 04:03:28:
Bought a 1955 ford 850 with original 6 volt setup. Harnes was cracked everywhere, but it still started with a quick tap of the starter button. Thought about the conversion, but I prefer to keep it 6 volt if all the parts were still available. So I did, I replaced the harness, and it still starts great, even in the dead of winter after sitting for months. mike
Follow Ups:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|