|
Tractor Talk Discussion Board |
Re: OT Digging a Pond
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by john in la on August 30, 2004 at 12:03:49 from (66.157.51.169):
In Reply to: OT Digging a Pond posted by Peanut on August 30, 2004 at 11:07:19:
I do not know where you live but will presume it is in the south and this is a dug pond on flat ground and not a levee pond. 1) you need to have the soil tested to see that it will hold water. 2) you need to dig it at a slope for easy exiting in case some one falls in but it needs to reach 4ft deep as soon as possible. This prevents weeds from growing. 3) you need to keep it in the 4-5ft range because any deeper and you may have oxygen depletion from water turn over in storms. 4) you need to think about where the water is coming from to fill pond. Water shed?? do you have enough land?? streams are a bad choice because they put in unwanted fish. What is this clean water source you have?? A Well ?? 5) you need to adjust your input and output of water because too much will allow your nutrients to be depleted. You only want to replace lost water due to evaporation. I know this is hard to adjust but what I am saying is you do not want a stream running through the middle of your pond. 6) The size you have picked is about right since Bass need at least 1 acre to multiply. I could go on and on but this should get you to thinking. Go to the LA. MISS. ag web sites and look up ponds. They have a bunch of ligature on recreational and farm ponds and read away as we are both very big into catfish farming. I think ARK. and ALA. have some info also. I will link you to one HERE
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Grain Threshing in the Early 40's - by Pat Browning. The setting is rural Wisconsin, halfway between East Troy and Elkhorn, on Hodunk Road, our nation was at war, and I was 6, 7 and 8 years old. George was our "threshing neighbor." He was the one with the threshing machine, a JI Case on steel wheels, and he pulled it to our farm with a JI Case standard tractor also on steel. In those days, steel wheeled implements were common. The roads were general gravel, so the lugs cutting into them wasn't a problem. George would set up the thresher, s
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|