Tractor Talk Discussion Board |
kmokgm@a-m-u.net
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by K-Mo on August 28, 2004 at 05:13:22 from (65.169.189.2):
In Reply to: Farmall Super A. posted by Don Gober on August 27, 2004 at 15:22:49:
The serial number should be on an aluminum ID plate mounted on the inside of the left seat mount bracket. I don't know that it holds true for the Super As, but on some early IH tractors the engine and chassis numbers matched. Your engine serial number should be on the front right side of the engine near the top edge of the block on a flat machined area. Stamped into the casting. Disregard the previous paragraph other than for general info. I just checked my Super A parts book and it states that no effort was made for matching the engine and chassis serial numbers on these tractors. K-Mo
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|