|
Tractor Talk Discussion Board |
infrared thermometers
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by joe in Pa. on August 27, 2004 at 20:41:00 from (24.97.71.2):
I bought one at a sale for $80. not knowing what I would use it for. its small hand held uses a laser beam and takes a tempeture from a couple inches to 15' or more away. I finished up rolling hay for the season yesterday and brough the round baler back to the shed with the last bale in it. I kicked on the PTO and took the thermometer and checked the temp of all the bearings. no crawing around, just point and shoot and you have the temp. all the bearings were between 90-95 degrees, except one it was at 125 degrees. now I can replace that bearing this winter instead of next hay season when I have hay on the ground. neat! it paid for its self
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Converting from 6 Volt to 12 Volt - by Chris Pratt. It's a common problem for old machines especially when the weather starts to dip below 40 and the tractor isn't fired up as often. You are probably used to the 12 volt Diehard, charged with 200 amp alternator of your 3/4 ton that always is ready and always starts. It's this type of experience that brings about the many queries we get for 12-volt conversion kits. Since only a few kits are available (we sell kits for the
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
