Re: Joh Deere Vibration

Posted by G-MAN on August 23, 2004 at 10:50:36 from (67.52.48.10):

In Reply to: Re: Joh Deere Vibration posted by MG on August 23, 2004 at 10:37:47:

The rotating assemblies were balanced together at the factory, i.e. the crank, clutch driver and flywheel were "matched" - I don't know if the pistons and rods were done with them or not, but I wouldn't think so. So installing a replacement flywheel or driver would technically throw the engine out of balance. But, when dealing with a big, slow-speed engine with huge parts, it's not much of an issue. Installing aluminum pistons will do the same thing, and make the engine tend to vibrate more than normal. What I don't know is if they marked every crank/flywheel/driver in the same location on the end.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]