Tractor Talk Discussion Board |
Re: Liquid Ballast vs. Iron Weights
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MarkB on July 30, 2004 at 04:00:01 from (64.31.11.188):
In Reply to: Re: Liquid Ballast vs. Iron Weights posted by Ron on July 30, 2004 at 03:09:25:
Sorry Ron, but you're mistaken. A rotating mass, such as a flywheel, stores energy. It does not consume energy. So it takes power to accelerate the wheel weights to speed, but no further power is consumed once the tractor is at operating speed. The energy stored in the rotating weights is recovered when the tractor is deccelerated, either by friction in the drivetrain, brakes or the implement in use. You can verify this with any physics textbook, or prove it yourself with a rotating mass such as bicycle wheel. Spin the wheel up to speed. Does it stop spinning when you quit applying power? No, although it will eventually slow down because of friction in the bearings. Now stop it by holding your hand against the tire. Did your hand get hot? That's because the energy stored in the spinning wheel was converted to heat.
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|