|
Tractor Talk Discussion Board |
Re: Re: front end to make a STONE BOAT.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by leo cech on July 27, 2004 at 07:29:43 from (205.243.25.52):
In Reply to: Re: front end to make a STONE BOAT. posted by Bob on July 26, 2004 at 07:59:46:
I have 2 stone boat heads they are factory made,they are quite heavy so they would have to be picked on my farm they are poured cast iron about 30 inches with rounded front with large hoel back end has a number of holes where you bolt oak planks . the idea of car hood could be used for small rocks but is much to light for large rocks, Leo cech browerville,Mn. email lcech@rea-alp Thank you
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
