|
Tractor Talk Discussion Board |
Re: Re: winch wiring
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mark - IN. on July 26, 2004 at 21:24:43 from (149.174.164.71):
In Reply to: Re: winch wiring posted by txblu on July 26, 2004 at 09:14:53:
You're right, the more pulleys that you add into the equation, the less the wench has to work, and the more pulling power. I tried to dead weight once with a 5 ton truck and broke the shear pin in the wench - the cable was banjo string tight because was pulling truck out of mud, and cable pulled into the cable wound on the drum. Couldn't move drum to loosen, couldn't budge truck. Took a dozer and log chain. I learned the hard way, one snatch block minimum. That old add showing the truck or jeep or something being pulled straight up in the air to a tree limb by a wench? Yeah, right.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
