|
Tractor Talk Discussion Board |
Re: Where do you all get the air dryer for your ai
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Stu on July 20, 2004 at 16:32:57 from (64.12.117.10):
In Reply to: Where do you all get the air dryer for your air ho posted by Nicholaus Sowder on July 20, 2004 at 15:56:26:
A refrigerated air dryer is rather pricy. There is a cheaper way to remove most of the air. First install a 1/4 turn ballvalve at compressor(usually a 3/4") Then come off of your valve with a flexible hose. Connect hose into a "T". Install a short nipple out of the bottem of the "T" with a drain. Run pipe out of the top to your quick connects. At each outlet install a "T" with a nipple & drain at bottom of "T". Istall your quick connect in the top. By running your air lies up & over to the locations of connectors it makes it harder for the condensation to get to the outlets. Always install a drip leg at low points and keep them drained. Also install a valve in the bottom of your tank to drain water. This can be an automatic drain or a manual ball valve. When you want to paint or sandblast (most important to have dry air) install a small air dryer fitting on your paint gun or sand-pot. Theese are availible at most tool stores. You can install your pressure regulator at the compressor or at each outlet. If you get an auto tool oiler make sure you don't use that port for painting or sandblasting. Hope this helps, Stu.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Stories From Old Farmer - by K. Pratt. Old Farmer, a.k.a. Dale Jensen began posting messages to our discussion forums at the grand age of 75. With extensive knowledge of farming and tractors, he valued the past and the ways that went with it. He shared these values with us until shortly before his passing. I spoke with Dale in his last days and requested his permission to share some of his stories with the readers of our magazine. He agreed, and provided the
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|