Re: Starter Solenoid

Posted by msb on July 14, 2004 at 13:06:46 from (12.203.216.208):

In Reply to: Starter Solenoid posted by JIM on July 14, 2004 at 12:39:00:

The solenoid engages the starter drive momentarily before the starter motor in energized so the drive is not alrady spinning when it hits the ring gear.Sounds like your drive isn't being engaged.Usually its the switch plate in the solenoid switch that gets arced and doesn't make good contact.On some solenoids it is possible to remove the plastic end cap and reverse the swith plate.It is most likely the solenoid switch but could also be a problem with the drive gear or the ring gear teeth.Depending upon how many cylinders an engine has, the engine always stops in one of two places on a 4 cylinder and one of three places on a 6 cylinder So the ring gear takes a bit of a beating in those areas after time.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Re: Re: Starter Solenoid Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]