|
Tractor Talk Discussion Board |
Re: Powder spray torch ?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by kyhayman on July 13, 2004 at 11:29:03 from (205.204.242.23):
In Reply to: Powder spray torch ? posted by chuck grandgent on July 13, 2004 at 04:46:36:
For the money I'd try 99% nickel on an arc welder. Even with school kids I can get them repairing cracks in castings, usually in 1 class period. Less nickel is good for joining steel to cast or other things but the challenge to using the rod goes up. Usually give them a 1/2 pound of nickel rods, propane blow torch to preheat an broken pieces of cast, and an A/C welder. At the end of 3 weeks of welding steel they get a day to weld cast horizontal, vertical, and down hand to tun in for a stress test, Only way to get better than a C is for the cast to break before the weld in the press. Better than 90% make it.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Antique Tractors a Passing Fad? - by Tractor Talk Forum Participants. A Talk of the Town article - Do you see antique tractors going out like a fad? Value has come down this winter. An example is the Ford Model A and T cars that went through this in years ago, along with the hit & miss engine. Will the younger generation move on to something else? Will it be harder to sell them and what models will be affected? Could we see the value crash on our rusty relics?
... [Read Article]
Latest Ad:
Ford 3-Point Single Bottom Moldboard Plow with Coulter
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|