|
Tractor Talk Discussion Board |
Re: O.T. Is $100 / hr. too much to pay?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Britt on July 12, 2004 at 19:37:03 from (207.69.137.21):
In Reply to: O.T. Is $100 / hr. too much to pay? posted by Rauville on July 11, 2004 at 17:18:22:
Like Marlow said. It is all relative. Does the per hour charge start when he gets the equipment unloaded and gets the first bucket full? Or does it start at his place before he gets the machine loaded on his truck? $100.00 an hour should be good for a 3/4 yard machine with an 80 foot boom. A smaller bucket/shorter boom means less effeciency and more time spent. So smaller bucket/shorter boom = less $$$$. IF, and it's a big IF, he gets right down to business, gets done and gets gone. You should be paying for the time that the machine is working. Make sure you aren't paying $100.00 an hour for him to grease/adjust/clean/load/unload, etc. You should not be expected to pay for repair time either. In other words have an understanding what is to be charged for and what is part of doing business. Most reputable operators will have a minimum number of hours to cover the moving in and out expences. Make sure that he has insurance, knows where all underground utilities and overhead wires are. Getting into those can be fatal, let alone expensive. I've been on both sides of this fence, and the circumstances above are fair. If he balks at it, shop elsewhere. Remember, the bigger the machine, more work gets done in less time, so it is worth more. Also you should get him to give you a rough estimate of what time he estimates it will take to do your job. It pays to be careful. Don't give anyone a blank check. & don't pay the full amount in advance.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Museum Coverage: The Stuttgart Agricultural Museum - by Cindy Ladage. While cold wind was blowing back in Illinois, in Arkansas, daffodils were in bloom, and the Magnolia trees were adorned with fragrant blossoms. Stuttgart, Arkansas was the site of this year's winter Minneapolis Moline Collector's show February 25-27, 1999. The show was held at the Oliver Museum created by Don Oliver, the pioneer of the four wheel drive tractor. Oliver along with Gale Stroh and Kenneth Bull using Minneapolis Moline tractors and parts created what has become known as
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|