|
Tractor Talk Discussion Board |
Re: Re: Re: Re: Re: Re: anyone running a sawmill o
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by sjh on July 12, 2004 at 06:08:01 from (66.153.13.189):
In Reply to: Re: Re: Re: Re: Re: anyone running a sawmill off a posted by Roger on July 12, 2004 at 04:59:17:
When you hammer a blade, you are putting tension in the steel. Every time the blade is hit with the hammer the more tension is put in the steel. IIRC the faster the blade speed the more tension you need on the outside of the blade. When the blade spins it causes it to expand. That is what hammering does. It controls expansion. When it heats up the blade expands more then you loose your tension. When the sawer is done with my blade it will be completely sraight edge flat. He told me a guy one time wanted his money back after hammering because it was not dished. He told the guy to go some place else. He only makes them flat. He is so busy it will take 2 months to gat my blade back. I do trust him with my life.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
