Tractor Talk Discussion Board |
Re: 3 point hitch top link tightness ?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Indydirtfarmer on July 12, 2004 at 04:09:51 from (66.83.236.250):
In Reply to: 3 point hitch top link tightness ? posted by chuck grandgent on July 11, 2004 at 11:16:21:
Most of your "better" mowers have some movement built into the top link mounting point. There needs to be some give there. A few people have made mention of the fact that a mower can rotate up and over, if the front edge of the mower deck hits something solid. A chain will allow that to happen. The chain isn't the safest way to do the job. It does however, supply that needed give. I do a lot of bush hogging. I have several real estate agents I mow for. My Woods or my Bush Hog mowers both have top link mounts that flex, allowing as much as a foot of give. They won't allow the mower to rotate more than about 30 degrees upward. Safe, and effective. Be careful. John
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|