Tractor Talk Discussion Board |
Re: B.P. Blaster
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wayne on July 10, 2004 at 21:03:59 from (64.12.117.10):
In Reply to: B.P. Blaster posted by Dick on July 10, 2004 at 07:16:14:
Everybody has their favorite and opinions seem to vary but we've tried everything we could get out hands on off the shelf or that we could convince our various venders to give us samples of and PB Blaster has always come out on top. You should be able to get it at NAPA, around here they always carry it. Everybody has a story about what turned them onto their favorite penetrant, here's what we ran into. We had a 8" shaft rusted in a gear years ago that we had put heat and 75 tons on and it didn't move. We set it off to the side for a couple days while doing some other things and kept it soaked in Blaster. Dad walked by it one day and just playing around hit the end if the shaft with a 4lb shop hammer and the shaft moved. From there all it took was a few minutes and it was apart. We have found other producst that seem to work good also but they always have something that make them unatractive to use, be it smell, a spray pattern that you can't "aim" at a joint, or that has such force it splashes back at you, etc etc. All in all Blaster is the best all around we have found . Just my .02
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|