|
Tractor Talk Discussion Board |
Re: Re: Advice on small engine needed.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by 8N127975 on July 05, 2004 at 13:42:18 from (64.12.117.10):
In Reply to: Re: Advice on small engine needed. posted by hlc on July 05, 2004 at 08:02:53:
I appreciate the tips. I finally lost patience and took the carb off and cleaned up with carb cleaner. I believe the float must have been stuck in the down position. I did check the float to see if it had gas in it. Cleaned up all the little venturis and ports. Got it running again and actually got the yard mowed. Whew! We've been gettin' rain on a more or less daily basis for the last month, so it was real important to cut it while I could. Tip on Snappers: You might as well take the tank off and run the engine dry before tipping on end to work on. I've gotten away with it in the past, but it bit me this time.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|