|
Tractor Talk Discussion Board |
Motor grader head gasket
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by tom on June 20, 2004 at 05:05:42 from (68.185.248.83):
I have a Champion 710 A motor grader with a 5.9 L cummings engine.I replaced the head gasket and now cannot get all the air out of the fuel system.I do not know where the bleed valve is on the injector pump or if even has one and the book I have does not show that pump.It has Bosh and the lines go in the front of the pump and our book shows a pump with the lines on the top.I have bleed all filters and when I pump using the manual pump no air is detected up to injecter pump.Would you know where to bleed this pump.I have cranked this engine way to much already and all I get is air at the injecters.Anybody know where is start to remove this air.The engine was running before I removed the head(just replaced head gasket because of leak.Tom
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Memories of a Farmall C - by Monty Bradley. When I was a child, my grandparents lived on a farm owned by a Mr. Walters. The crops raised were cotton and soybeans, with about forty head of mixed breed cattle. Mr. Walters owned two tractors then. A Farmall 300 on gasoline and a Farmall C, that had once belonged to his father-in-law, and had been converted from gasoline to LP Gas. Many times, as a small boy, I would cross the fence behind the house my grandparents lived in and walk down the turn row to where granddaddy would be cultivati
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
