|
Tractor Talk Discussion Board |
Re: Re: Re: OT New home wall thickness
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by T_Bone on June 12, 2004 at 08:05:09 from (4.240.42.58):
In Reply to: Re: Re: OT New home wall thickness posted by dhermesc on June 11, 2004 at 13:03:42:
Hi dhermesc, Sounds awful expensive for what you were quoted. A ground source HP can either be wet, uses well water etc:, or dry uses the earth as a heat sink. Ground temperature doesn't change very much yearly, 50� average 8ft deep, for most of the USA, and is why a GSHP works well and very efficient. Sizing HP HVAC units is a big problem in the industry. Most units tend to be sized for the refrigeration side and not for the heating side. Some areas due to the radical temperature swings a split or piggy back unit is best. Alot to consider to spec the correct unit system for a pictular area. I went to Alaska one time to spec a 50ton refrigeration system in a area that never got above 60� with very little humidity. Thats the gov't at work for you. T_Bone
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Implements and Their Use - by Curtis Von Fange. Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he reached his early sixties
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
