Tractor Talk Discussion Board |
Re: Painting with a BRUSH!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Alberta Mike on June 01, 2004 at 17:15:50 from (209.47.89.106):
In Reply to: Painting with a BRUSH! posted by Ben uk on June 01, 2004 at 12:45:02:
I've learned a few things about painting, some good things and some bad. All my suggestions relate to a good quality machinery enamel (which will never stand up to wear and tear or for color retention and fade resistance like a good automotive paint will). Having said that, machinery enamel brushes on any rough or unmachined castings very nicely, I'd say looks every bit as good as a spray job on those parts. As for the tinwork, there's no way you can hide a brush job but what you can do (another fella mentioned it below) is roll the paint on. Some areas are tough or impossible to roll so you might have to do some brushwork but the rolling works well. I've used one of those small 4" rollers (good quality ones) and had good results. Make sure you vacumn it well and brush it off well before you paint or you'll get those little fuzzies in your finish. Maybe paint some scrap sheet metal you've got kicking around for practice first. It'll also get rid of some of that fuzz. It will be a bit "orange peel" but it will look good and the decals will go on fine once they dry out. Last, spray cans don't lay down much paint, most of the can is just the solvent carrier liquid. I also find that spray can paint fades quickly and in some cases changes color. Last advice is to keep your machinery enamel painted tractor out of the sun as much as possible or fading is inevitable. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|