|
Tractor Talk Discussion Board |
Re: Re: Re: Re: Re: Re: Re: ford truck engines
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JerryG on May 23, 2004 at 18:07:45 from (216.98.174.217):
In Reply to: Re: Re: Re: Re: Re: Re: ford truck engines posted by Loren on May 18, 2004 at 20:00:17:
The 351M and 400 were the same engine design. The deck was taller on the 400. The transmission bolt pattern is the same between the 351M/400 and the 429/460 385 series engines. You have to use the flywheel for the specific engine that your using.
The Boss 302 was also mentioned. It uses a 90 degree 289/302 block with Cleveland type heads. The intake is a special item that only works on this engine. The 351W is the same engine design as the 289/302. The 351W did have a higher deck so that a longer rod and stroke could be had. The crank also had larger journals.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
1938 John Deere LI
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
