Re: Ignition Timing

Posted by Jerry/MT on May 22, 2004 at 19:50:52 from (206.231.182.246):

In Reply to: Ignition Timing posted by Jimmy Lynn on May 22, 2004 at 15:41:24:

Get the engine near Top Dead Center (TDC) with the distributor rotor point at the #1 plug wire terminal. Inch the engine with the starter or a big wrench on the cranksahft pulley nut to the correct timing mark. Be patient and get it right on. Take the #1 pug wire of the spark plug, put a paper clip in it and get it to a good ground. Loosen the distributor and turn on the key. Holding the plug wire about a sixteenth of an inch away from the ground, rotate the distributor slowly til you hear the pop of the spark.The point where it pops is the correct timing. Do it until you get it right. Tighten down the distributor and hook up plug wire and start it up! Check with a timing light and then check that the advance mechanism is working and your done. Hope this helps.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Re: Re: Ignition Timing Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]