|
Tractor Talk Discussion Board |
Re: john deere 70
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Scotty on May 20, 2004 at 13:51:14 from (68.58.25.78):
In Reply to: john deere 70 posted by dave on May 20, 2004 at 12:52:34:
Crankcase should hold 11 quarts! (according to I & T shop service manual # JD - 10). There is a drain plug on the bottom of the Oil Pan that has a brass seal ring on it. The nut takes a large wrench (I think about 1 1/4 - 1 1/2" by memory). The oil change is more effective if You run the tractor for several minutes at a higher RPM to get the dirt mixed up in the oil, & drain it warm, or hot! I always refill the air cleaner while I am at it! The nut to remove the oil filter is located on the bottom close to the oil pan. It has a round protruding lid about 6" +/- across with a nut in the center. Be careful when removing!!! I cant tell You how many times it fell in a 5 gallon bucket, & splashed all over me! The filter popps straight down. The gasket will probably be stuck in the grove that the lid fits in!
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|