|
Tractor Talk Discussion Board |
Re: Biggest engine you've ever heard of
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John A on May 17, 2004 at 19:52:48 from (63.156.152.40):
In Reply to: Biggest engine you've ever heard of posted by Jim A. on May 17, 2004 at 18:29:28:
Jim A., Biggest engines is ever saw were the Generator units @ Gray Army Airfield @ Ft Hood, Tx. They were in the "Holes" caves out of a mountian. Built to withstand a nucular blast and the two unit were to supply power to those left inside. Both uiits were mirror immiages of each other. Anyway If I can remember they were Inger-sol Rands. Pistons the size of 30 gal oil drums. Rockerarms the size of 4in X 6in X 4ft. The Armature was 12ft diameter X 4ft thick, round! The engine was about 35 to 40 ft long. These units were scrapped, so I heard in the mid 80s. Saw my Dad run them a few times before they were scrapped. OBTW.... Thes units were @ the Port of Houston about to be loaded on to freightors when the Cold War broke out........ About to be loaded........Like hooked to the crain....In the air, being swung to the Russian freightor. They were recalled, and sent to Ft. Hood. They arrived with instructions In Russian. A little history Ya'll might find instersting. Later, John A.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let�s make one more addition to our series on hydraulics. I�ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|