|
Tractor Talk Discussion Board |
Re: Bury H2O Line w/ Bobcat?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmer in the Dells (WI) on May 16, 2004 at 09:33:49 from (66.187.42.49):
In Reply to: Bury H2O Line w/ Bobcat? posted by Rauville on May 16, 2004 at 07:07:42:
you might try a neighbor that has a three point one bottom plow. They could lift the back high enough and angle it so the point is the only cutting edge. You could also get a single cultivator knife or springtooth to mount on your bobcat. I have seen some knives already V shaped and drilled for carraige bolts. Any of these could turn a lip of the sod over and after you trowel out some dirt and place your line you could roll it back. Driveways are another story. We had a gas line buried and the 12 foot driveway tool longer than the rest of the 100 foot run. Amazing what 100 + years of wagons, milk and grain trucks, fuel delivery trucks and semis, and my tractors of course, will compact. Don't forget to add thumb screw "t"s at the ends and maybe an air fitting exposed so you can easily blow it out in the fall. Check the RV section of your hardware store. They should have it all in a kit form for refrigerators if not piece by piece. I also dropped a phone line in the trentch to add a hardline phone in the barn later as long as I was digging. Good luck
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|