Tractor Talk Discussion Board |
Re: New Diesel Pickups? Lets be Nice
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Scotty on May 09, 2004 at 14:59:07 from (68.58.25.78):
In Reply to: New Diesel Pickups? Lets be Nice posted by Redd on May 09, 2004 at 08:17:01:
I have a 97 Dodge 2500 4x4 5.9 Gas automatic I wish someone would steel!!! Here's why! 1) Engine went at 47,500 Miles 2) Torque Converter at 60,000 3) Transmission at 84,000 4) 14 computer failures related to the engine 5) Fuel filter in the gas tank of all places 6) Dodge refused to accept any responsibilty at all for repairs I was offered an extended warranty, & stupidly turned it down. They wanted $2000 for it. The Chevrolet I traded only cost $600 for the warranty 3 years before! THAT RIGHT THERE SHOULD HAVE BEEN WARNING ENOUGH TO WALK AWAY! By the way the vehicle now has 115,000 miles on it, & it it parked in the barn collecting dust with a bearing out of the drive shaft. Its so bad I wont sell it to any one. Next time it moves its going to the junk yard! I bought a 94 Chev 2500 with 350 gas 4x4 auto with 230,000 miles in October, & I have put 14,000 miles on it, & I have only spent $90 on repairs for the heater blower motor! Although I really like it; But I wish I had bought a Diesel... After spending 11,500 out of my pocket on that Dodge I didnt want to spend that extra money at the time on a diesel! Also the Dodge had 95% of the time been driven 40 miles to work with 80% of that being an interstate highway. There is absolutely no reason for that many failures to happen!
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|