Re: Making a flywheel

Posted by Redman on May 03, 2004 at 18:51:06 from (66.44.173.236):

In Reply to: Making a flywheel posted by Peter Treml on May 03, 2004 at 13:45:42:

how hard are you going to spin it?is the flywheel on either a steel pulling flywheel?
cast is only good to 3500 rpm for any period of time.
this is what i did,had a 1256 puller switched engine to a 436.took the steel flywheel to a machine shop and had them relocate the holes,weld the old ones shut and redrill then surface everything.
spins 6000+ and has not bothered yet.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Re: Re: Making a flywheel Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]