Re: Super A engine

Posted by Loren on May 02, 2004 at 21:43:12 from (12.108.31.7):

In Reply to: Super A engine posted by Bill Caldwell on May 02, 2004 at 20:22:50:

I just made a puller for my B a couple weeks ago. Turned a round torch drop to 4.125" at 0.5" long down to a step at 3.875 for 0.25". Drilled a .75" hole in it for the pull. Turned a 2.75" long round tube to 3.875" id and 4.125"od for the spacer(drill pipe, odd dimensioned stuff). Turned another round torch drop to just under my bore at 2.995 with a 3.125 shoulder and 1.5" thick. Drill it also. I welded on a Redi-rod to the slug that fits in the bottom of the cylinder and lubed it good. Worked like a champ. I asked here about the length of pull needed and was told correctly that about 1/2" would do it. Only hand wrench pressure did the job. My sleeves are the smaller size OD inside the block and a 3" bore. I don't know where you'd have to modify for your Super.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Re: Re: Super A engine Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]