|
Tractor Talk Discussion Board |
Re: Re: Briggs 11 hp won't run
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hal/WA on April 27, 2004 at 22:19:56 from (148.78.243.26):
In Reply to: Re: Briggs 11 hp won't run posted by pasbon on April 27, 2004 at 13:04:09:
I have also had the gap on the intake valve become too tight or non-existant and the symptoms my engine had were hard starting and spitting back through the carb while the engine was being cranked. When I dug into the engine, I found that the intake valve was not making a good seal on the seat when the valve was at the lowered position. I removed the intake valve and ground a small amount off the end of the stem. I also hand lapped the valve to the seat with valve grinding compound. Before I put it all back together, I verified that the clearance between the valve stem and lifter was within specifications. The engine then would start and run fairly well and I used it another year. For awhile before I was forced to do the repair because it just wouldn't start anymore, the engine could be started with ether, and once it was running, ran OK. I suspect that over time the valve and seat wear, causing the valve to be further into the engine block and reducing the clearance between the stem and lifter. I did compression tests as part of my diagnosis and did not get extremely low readings like I would have expected from a burned valve or bad rings. Confusing..... I suspect that the leaking intake valve caused a totally wrong mixture for the engine to start, with the air leaking back into the carb/intake manifold, and that was why the engine would start for awhile with ether, until the leaking valve got too bad. Good luck!
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|