|
Tractor Talk Discussion Board |
Re: Briggs 11 hp won't run
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Robert on April 27, 2004 at 15:58:50 from (199.245.220.253):
In Reply to: Briggs 11 hp won't run posted by Jerry Seilhamer on April 27, 2004 at 12:19:44:
I have some limited experience with Briggs, and, it sounds as if your problem is fuel related. You said it was running, then quit, now only backfires through the carburetor. With that information, if it were mine, I'd begin by carefully pulling the carburetor, dismantiling, then try to see what the fuel level is in the bowl. While there, I'd check to make sure the float hasn't developed a pin hole, allowing it to become "heavy", thereby not shutting fuel off---essentially flooding the engine. Depending on the type carburetor you have, there's probably a mixture adjustment screw. On my 8 hp Briggs, there's a nozzle located beneath the screw---you have to remove the screw, then screw out the nozzle, to clean passages. There's also a fuel "pump" of sorts on these things, that works off the valve pulses somehow, and to find if there's a problem in this area, look to where the rubber tube goes (I'm talking about the tube that's on the air cleaner)follow the routing, and take the cover off, make sure the little diaphragm isn't cracked, or has trash behind it. I don't think your problem is major, just frustrating. The fuel is most likely okay. I haven't found fuel to deteriorate over the course of a winter, but it would be easy enough to drain and refill. I hope this is of some help. Good luck!
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let�s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|