Tractor Talk Discussion Board |
Re: Sand Blasting
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Nebraska Cowman on April 21, 2004 at 08:56:16 from (65.172.142.89):
In Reply to: Sand Blasting posted by CH on April 21, 2004 at 08:42:27:
25 # won't even get you started. Around here you can buy blasting sand from the readymix concrete plants. I have never blasted a tractor but when I was a kid working in town we blasted the molds that were used for molded rubber products. That was my Saturday morning job. Took a lot of time and is very dusty, you wear a helmet with fresh air input. We worked inside on a concrete floor and reused the sand. Big heavy industrial compressors that ran 24/7 and 1½ hose and it was still slow. I would never attempt it at home. Use your blaster to clean spark plugs. Just drill holes in a wooden 2X4 and stick the plugs in the holes to hold them. You will be very happy.
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|