Tractor Talk Discussion Board |
Re: Ford Powerstroke
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kent on April 21, 2004 at 07:22:50 from (12.214.34.211):
In Reply to: Ford Powerstroke posted by Scott KY on April 21, 2004 at 04:29:49:
Scott, Remove the 3- nuts that hold on your emergency brake and behind it you will see your "computer" (PCM), it will look like a alum. box. On the end that faces the rear of the truck you will see an add on chip that will plug into that end of the PCM. If it has had a programmer installed, you will have a more difficult time finding that out. I am not sure how other than maybe having a dealer plug in the port under the glove box area and check it or someone else with a programmer. The advise of checking TDS is a great site and ALOT of helpful people there.
Follow Ups:
Home
| Forums
Today's Featured Article -
Seeing an Old Friend - by Joe Evans. Dad had a concrete contracting business starting in 1960. One of his first pieces of equipment was a Ferguson TO-35 with a Davis loader. Dad replaced the TO-35 with a MF 202 Workbull, essentially an industrialized Ferguson 35 I am told. Dad bought the 202 new in 1962, and I recall quite clearly going to the dealer with him to sign for it.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|