|
Tractor Talk Discussion Board |
Re: Submersible Pump Question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by TomR Ont. on April 14, 2004 at 18:15:35 from (209.226.138.118):
In Reply to: Submersible Pump Question posted by trkr on April 14, 2004 at 17:14:40:
I had a simular problem, may symptons were an intermittent snapping, fast re-cycling of the pump (turn on a tap and the tank pressure went low fast the pump would come on, build pressure fast, then repeat about every 7 seconds while the tap was on or flush). My submersible is 220-240v, I took the control box off (just pulls out) and took it to an electrical co they changed the capasitor and something (can't remember the name of it) else that wasn't included in the one at the hardware store. $ 85.00 + $35.00. Then I re-set the Air Pressure and High - Low Limits as per instructions on the tank. p.s. I was told if I left it snapping it would have damage the pump. Hope this helps.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Engine Basics: Spark Plug Cleaning - by Staff. Cleaning procedures: Brush or blow dirt from around the spark plug base. Remove the plug with a correctly fitted wrench. Examine the porcelain insulator and points. If the insulator appears to be melted or blistered, cracked or broken, and the points seem unduly burned it is evident that the plug is operating too hot and it should be replaced with a colder plug. If the plug is fouled excessively with carbon it apparently is operating too cold and it should be replac
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|