|
Tractor Talk Discussion Board |
Re: Onan no spark while cranking but fires when ke
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tom in TN on April 09, 2004 at 08:04:22 from (64.12.116.80):
In Reply to: Onan no spark while cranking but fires when key is posted by Steve on April 09, 2004 at 05:25:53:
Steve, I think that Ron in AR is on to something. I don't know about your Onan engine, but commonly, there will be a resistor in the primary coil circuit. If that resistor exists, there is usually a wire from the "Start" connector on the ignition switch or from a small connector on the starter solenoid etc., that provides the full battery voltage to the coil during starting (bypassing the resistor) but then goes away when the ignition switch is released to the "On" position. With the switch in the "On" position, the battery voltage is applied to the resistor which reduces the voltage that is subsequently applied across the coil. So, if battery voltage is not getting to the coil when the ignition switch is in the "Start" position, the engine won't have any spark while cranking, but when the ignition switch is released to the "On" position, it will have spark and might start. You might want to ascertain whether or not you have an external resistor, and then how that resistor is bypassed during starting. I think you might have a problem in that bypass. Good luck, Tom in TN
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Weldin Basics, Part 3 - by Curtis von Fange. Oxy-acetylene Welding - Part One In our series on welding we have taken a brief look at AC and DC arc welding along with basic techniques and safety equipment required for safe usage. Since our premise is to cover welding types that might best be used on a farm environment we have kept our overview purposefully simple and general. The second type of welding that this observer finds quite useful in
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|