Tractor Talk Discussion Board |
Re: Junk, or the next generation?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Nebraska Cowman on February 18, 2004 at 10:32:46 from (65.162.146.147):
In Reply to: Junk, or the next generation? posted by Scott on February 18, 2004 at 08:33:33:
maybe this is off topic but i was thinking the other day, with the technolgy that we have there is no reason we couldn't produce throw away cars that would run 100k and never do anything ecept put gasolene in them. keep the body style simple and they could be produced for less than $5000 i guess tractors could be the same way and maybe some if these imports are. when they wear out there will be noting left to fix. We live in houses built the same way. 2x4 rafters and plywood roof, what happens in 20 years when the shingles need replaced? will the sheating hold nails again? so you tear that off? what about those rafters? just bulldoze and start over. i think I'll keep my old tractors just in case.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|