|
Tractor Talk Discussion Board |
Re: Pulling Tractors
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob-Wyo on February 17, 2004 at 18:29:23 from (205.188.208.73):
In Reply to: Pulling Tractors posted by Oliver Owner on February 17, 2004 at 14:57:18:
Oliver Owner, I too am way past the hip replacement for the same reasons as you. Was going to have it done after Christmas, but then there were pulls coming up.lol I can tell you this my dad has his done at 84 after putting up with pain for many years, 2 weeks after he had it done you couldn't keep up with him, no cane, and couldn't detect even a limp, said the last pain he had was just before thay gave him a shot. I have set my tractor up for 7500# and that is where it will stay, should have done it sooner. There is a new operation called (The Zimmer Minimally Invasive Solutions), (MIS),SAYS RECOVERY AND REHAB is faster and easier. Instead of a 10 to 12" incision it is now only 2,1 1/2 to 2" incision and not having to cut through muscle and tendons witch is what causes the slow recovery time. To make us feel better it says over 150,000 total hip replacements are done in the US each year. lol To see if there is a surgeon close, you can go to www.pacewithlife.com or call 1-866-FIND-MIS My freind I'm with you on this, as nothing is for sure in any operation, as my Doc said there is always a chance of blood clots and getting the new in a degree or 2 off, but the chance's are slim. Please keep us up on your decision and best of luck always, Bob
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Storing Your Tractor - by Staff. If your tractor is going to be stored for any length of time, a few precautionary measures are helpful in preserving various parts, also in avoiding future difficulty. Store tractor under cover. If impossible to place tractor under cover, be sure to cover air stack and exhaust pipe. Drain radiator and engine block. To avoid gum content collections, drain both fuel tanks and carburetor. Leave radiator and fuel caps slightly loose to protect gaskets. Block tractor up to remove weight from tires and to keep tires from contact with moist floor.
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|