Tractor Talk Discussion Board |
Re: MF35 AXLE SEALS
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Big Dean on February 11, 2004 at 13:42:05 from (205.188.208.73):
In Reply to: MF35 AXLE SEALS posted by Mike on February 11, 2004 at 11:52:43:
The preload on the axle bearings is determined by how tight the two axle shafts butt together in the center. Changing sides with the shims will not change how much preload your bearings have. If they are to tight you will have to add a shim or shims on one side or the other preferably the side with the least shims. There will probably be some disagreement on this but with both wheels off I would put the transmission in gear if you can turn the axle by hand it will run as is and be fine. If not add shims till it will with no end play in the axle shaft. I have set many this way some as long ago as 20 years & they are still running.
Follow Ups:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|