|
Tractor Talk Discussion Board |
Remote hydraulics questions (kinda long)
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bud on February 11, 2004 at 09:13:08 from (148.64.47.177):
I am building a fence post driver for my tractor. I am pretty green on hooking up the hydraulics. I have three cylinders. One to lift the driver weight, and two for lateral leveling (fore/aft and side/side) The tractor that I am using is a Case 1070 with two remotes. The levers inside the cab are spring loaded to return to a neutral position when not in use.
My questions are;
1. Can I bungee the cab lever to provide a source of hydraulic pressure to the driver which then has it's own control valves to operate the three cylinders?
2. I have seen commecial drivers work and the operator pulls a control valve lever which operates the lift cylinder mechanism and when the operator lets go of the control the cylinder "free falls" back to the retracted position. If I have the cab control bungeed open, will I still be able to do the same also?
3. I am confused as to the difference between double and single acting cylinders. I would assume I think that I need a single acting cylinder for the lift cylinder. What about the other two position cylinders?
4. I am also confused about what type of control valve to buy to allow me to operate the three cylinders off the tractor.
Yes I am totally green when it comes to hydraulics and if someone would be so kind as to perhaps draw me a schematic I would be well on my way to fence post driving nirvana! :) I will post pictures for the board when I am finished with the construction. Thanks in advance for any help and if someone needs to email me with [email protected]
Thanks again folks!
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Buying your first tractor: Choosing the right one - by Chris Pratt. They cost less than the tax on a new tractor (at least where we live). They have the weight to do the job. They are simple and understandable. They even have a history and can be restored to become a major source of pride and enjoyment. But how do you know what to buy and how do you make the right purchase? There is a surprising number of machines available in every shape and size imaginable. Like most things in life, your needs have a lot to do with wh
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
